It is not very recurring that cars have failures due to a faulty ignition switch. However, it can occur due to wear and tear, but when faced with a situation like My car doesn’t do anything when I turn the key.it is obvious, that it is due to a cause that must be discovered, generally the most frequent is a dead battery, corroded terminals Inter alia. Here we present them and what to do in any of the situations.
What should be done when my car doesn’t do anything when I turn the key?
The first thing to do is find out the fault that is causing the car to do nothing when you turn the key in the ignition. Next we will mention the steps to follow to detect what happens:
- You should cycle the battery approximately 10 times continuously, leaving a 5 minute break on each attempt.
- Strike the battery terminals lightly with a hammer or the heel of your shoe.
- Move the gear lever and try to start the engine, this should be done in the case of a car with a manual transmission.
- Check if there are any visible symptoms of failure in some parts that make up the engine: fuel pump relay.
- Check for leaks in gasoline or oil tanks.
Why does my car key turn but the car won’t start?
It is vital to know the reason that can affect when the car if turning the key in the ignition switch does not start the engine. Let’s see some reasons that lead to the car not starting after turning the key:
weak battery
The car battery has a useful life between 3 to 5 years, then it is necessary to replace this part of the car. It will usually detect when the battery needs to be replaced because it starts to notice faults, among these the engine does not start after turning the key.
Corroded battery terminals
Corrosion on the car battery terminals affects the efficient supply of energy in the various systems of the car, including ignition. This failure is caused when the hydrogen gas released by the battery reacts with the sulfuric acid in the battery. Many car batteries offer durability to reduce the risk of corrosion at their terminals. But, the dangers of corrosion can be more serious than usual when the battery is overcharged or improperly charged.
loose connections
A Bad battery connection can cause the engine not to start after turning the car key. a symptom of loose or loose connections in the car battery, is when the car shakes while driving. Frequent vibrations can loosen the cables, being a reason why the engine does not start when you turn the key.
Faulty fuel pump relay
A Unexpected surge in battery power can cause the fuel pump relay to go bad. The entire system is responsible for transferring and maintaining continuous voltage from the ignition to the engine. In case this part presents problems, when you turn the key in the ignition switch the car does not start.
flooded engine
Exceeding the amount of fuel in the car can prevent air from flowing properly in the engine. This it can cause the ignition to not contact the piston, which would cause an engine problem.
cold engine
Very frosty weather periods negatively affect the engine and ignition of the car. Low outside temperatures can result in engine oil thickening failures, which turns into a lockup and ultimately wears out the battery. If you’re thinking the car won’t start because the battery is cold, don’t keep trying to jump start the car. This can cause the battery to explode, with serious consequences.
How can an ignition switch be replaced?
Many times, the Damaged ignition switch is one of the main causes of the car not starting after turning the key. Replacing this device may restore the functionality of the car’s ignition. You must make sure that the ignition key module to be changed is the correct one for the car, otherwise the failures will continue.
Steps to change this pizza
- You should have a screwdriver handy.
- Remove the top of the ignition key assembly, prying it open with your hands.
- Remove the dash panels that cover the screws that hold the plastic casing under the steering wheel.
- Unscrew the screws and carefully remove the plastic casing.
- Rotate the flywheel 90 degrees counterclockwise to visualize the bolts.
- Remove the screws and remove the panel.
- Insert the small bracket (stick) into the ignition switch hole to release the assembly.
- Replace the ignition switch assembly with the new component.
- Reinstall the removed components and other assemblies.
- Check the switch to make sure it has been properly positioned.
How to replace car battery at home?
Before change battery, It is important to have on hand the correct model that the vehicle uses. Do not think of installing a different battery to the model that the car has, it can affect the alternator with overheating, which impairs the life of the system and severely damages the engine block.
Steps to replace car battery
- Choosing the correct car battery, considering several factors when buying the part, before making the decision it is important to consider:
- Technology: Car batteries are generally categorized into two different types of technology: starting and deep-cycle
- Reserve Capacity (RC): The normal amount of time it takes for a car battery to run, should the alternator fail.
- Size: Battery must fit properly in the car’s battery holder
- Cold Cranking Amps (CCA): The battery’s ability to crank in extreme freezing temperatures
Tools needed to change the battery:
Socket wrench, socket extension, wire brush. Now you must comply with the following:
- Put on a part of gloves, loosen the nut of the negative terminal of the battery
- Repeat the previous step with the positive terminal
- Remove the clamps and brackets that hold the old battery
- Take out the old battery from the holder and replace the new one
- Connect the wires to the correct terminals
- Close the hood, try to start the car engine by turning the key in the ignition switch.
Conclution
Turning the key in the car’s ignition switch does not start the engine, the fault may be caused by a depleted battery. Other reasons that can cause engine or ignition misfires are due to loose or loose battery connections, as well as engine leaks. The first thing to do is locate the source of the problem.
It may interest you
- PWhy does my car turn off when I stop?
- Car does not start but turns on radio lights
Writing Gossipvehicle